EYE OF THE KIGER

Note: Perform at your own risk. All Photos Property of Tony Kiger Tools Needed: 1. T30 Bit 2. Rachet to accept T30 Bit 3. Thin Panel Pry Tool 4. Painters Tap...

Note: Perform at your own risk. Tools Needed: 1. Panel Pry tool 2. 17mm Socket 3. Impact or breaker bar 4. T40 Bit 5. Ratchet Wrench (to accept T40 Bit) 6. ...

Note: Perform at your own risk. Porsche 911 "992" interior triangle is fixed to the door panel. Do not try to remove. Tools Needed: 1. T20 Torx Bit 2. Ratc...

Revision: 3/8/2020 Note: Perform at your own risk. Tools Needed: 1. T30 Torx Bit 2. Ratchet Wrench (to accept T30 Bit) 3. Slim Panel Pry Tool All Photos P...

Note: Perform at your own risk. All Photos Property of Tony Kiger Displayed above you will notice that the "992" has a trim cover over the engine bay (coolan...

Note: Perform at your own risk. Starting with passengers side mirror: First, open passengers side door for access of inner door panel. Ensure that the window...

Note: Perform at your own risk. If you are able to raise the rear end and remove both rear wheels, this will make the process much easier. If not, we will co...

Note: Perform at your own risk To remove the front fender vents you will need: -3M Double Sided Automotive Tape -3M Painters Tape -Fishing Line -Panel Pry To...

Note: Perform at your own risk. The steps to follow will explain how to easily remove the exterior door handles on a 2018-present Jeep Wrangler (JL Body). St...

Note: This is not recommended for anyone without proper experience. Perform at your own risk. First we will start by opening the hood. With the hood open, no...

Listed below will follow directions on how to remove the double fixed wing on a 2016+ Porsche 911 Carrera GTS Start by releasing the Engine cover. Switch loc...

Keep in mind, this 2015 GMC Sierra has fender flares, so the instructions may vary a little. First start by opening the hood. Once the hood is open, you'll f...

Below is a link to Rupes USA interactive parts page for the LHR75E For warranty support: https://rupesusa.com/repairs/ Notice: This guide is for those that c...

Pictorial by: Tony Kiger For Rupes Nano parts: https://rupesusa.com/wp-content/uploads/2018/03/HR81L-HR81ML-interactive-parts-diagram2018.02.21.pdf For warr...

Step 1: Open rear trunk hatch. Step 2: Locate the plastic taillight shroud cover and pop it off (held in by plastic tabs, just pulls off). Step 3: Under the ...

Step 1: Open rear engine hatch Step 2: Locate carbon fiber cover on underside of engine hatch. Step 3: Remove “12” T20 screws holding the carbon fiber cover ...

Step 1: Start by taping off beneath the taillight and at the front most corner of the light. This will ensure no damage to the paint during removal. Step 2: ...

Step 1: Lift Vehicle from front lift points (dedicated lift preferred over a floor jack). Step 2 : Open Hood. Step 3: Remove front wheels. Step 4: Remove “3”...

Step 1: Raise rear spoiler (button located on center console). Step 2: Open engine cover (switch located on drivers side kick plate). Step 3: Pop off center...